Common faults and solutions for sand making machine link lines?

SHANGHAI SHIBANG MACHINERY CO., LTD is one high-tech enterprise, which involves R&D, production, sales and service as well. In the past 20 years, we devote to producing mining equipments, sand making machines and industrial grinding mills, offering expressway, rail way and water conservancy projects the solution of making high grade sand and matched equipments.

Common faults and solutions for sand making machine link lines?

Everything is not pre-emptive, and it is helpful to understand the common faults and solutions of the sand making machine linkage line. It is beneficial to the correct operation of the sand making machine equipment. The sanding machine equipment needs to pay attention to many problems during the use or installation process. The most concerned is the problem of the sand making machine connection line. So what is the connection line of the sand making machine, and what are the common problems of the sand making machine connection line?

As we all know, if we take the wrong connection line of the sand making machine, it will cause a lot of trouble, and sometimes even burn out our equipment, so SBM gives you a summary of the maintenance and connection points of the wire making machine:

  • 1. The maximum load current through which the wire of the sand making machine, sanding machine, etc., passes should not exceed the allowable current of the ride.
  • 2. The fixing frame and the fittings of the successive sand making machine (sanding machine) shall be free from serious rust and deformation and decay. The rust of the fixture’s fittings should not be peeled off and there should be serious pitting, and the rust surface area should not exceed 1/2.
  • 3. The joint of the steel strand (ground) is free from discoloration and severe corrosion. The bolts of the connecting clamp should be firm, and the strand (bottom line) should be free of strands.
  • 4. The suspension stress of the low-voltage overhead cluster line should be smooth, and the distance between the conductor brackets must not exceed 1M.
  • 5. The end of the bundling line of the sand making machine should be well sealed.
  • 6. The insulation layer of the cluster wire should be well-rounded, without peeling and cracking.
  • 7. The connector and cable clamp should be free from overheating.

When the customer purchases the sand making machine equipment, what we have to do is to wire the sand making machine. I hope everyone can install what we call docking, which not only saves us time, but also makes our safety performance greatly. Improvement, if we do not understand the use of the place, you can consult our SBM sand making machine engineers, we will be happy to help you.

Inquiry

Please fill in your name and your message and do not forget mail and/or phone if you like to be contacted. Please note that you do not need to have a mail programme to use this function.