Common faults of ultrafine mill

Common faults of ultrafine mill

The material produced by the ultrafine mill has a higher fineness of the finished product. Generally, the mesh number is the unit of measurement. It is known in the industry as a sharp tool for processing ultrafine powder. After the milling equipment has been running for a long time, it will inevitably produce a certain amount of wear and tear, and faults may occur on different components, resulting in different degrees of damage, which will affect production efficiency and economic benefits at the same time. This article summarizes the common failures of the ultrafine mill, hoping to help users resume production in a timely manner and reduce losses.

未标题-1

The heating of the oil tank and the rotating device of the ultrafine mill is a common failure. Because its classification process is performed by the rotating device to drive the impeller of the analyzer to work. At this stage, if the transmission device and the lubricant in the oil tank of the analyzer are working, The viscosity is too large, and the lubricating oil cannot be sent into the rolling bearing, which causes the bearing to run out of heat due to lack of oil, and at the same time, the transmission device and the analysis engine oil tank generate heat. In addition, if the analyzer runs in the opposite direction, the current of the entire mill will increase sharply, the temperature of the analyzer will also increase, and the transmission device and the fuel tank of the analyzer will generate heat. In such a failure, we should check whether the viscosity of the oil meets the requirements and check whether the analysis machine is running in the reverse direction. When the ultrafine mill does not produce powder or too little powder, it will affect the output of the mill. Due to the tightness of the powder lock, a large amount of powder will leak out and the finished powder will be reduced. The effect is weakened, resulting in too little flour. When this kind of failure occurs, we should check the seal state of the powder locker in time, detect whether the blade is worn out in time, and replace it with a new one if necessary to make it reach normal working conditions.

The above describes the failures that often occur in the daily operation of the mill. In actual operation, the user needs to observe the operating status of the ultrafine mill regularly. Once abnormal conditions occur, professional staff must be inspected in time.

Hot Products